Pipe Trades Pro 4095 - Rolling Offset - Known Bend Angle

USER’S GUIDE — 33
6 and 1/4 inches, and outer arc length of 8 and 9/16 inches.
Note: To return the Welder’s Gap to the default 1/8”, press
  to reset your calculator back to default values.
Rolling Offset – Known Bend Angle
Find the center-to-center travel for a rolling pipe offset with a 4”
Roll and a 24” Offset using 45° factory-made long radius butt
weld elbows.
ADVANCE
LENGTH
OFFSET
ROLL
BEND
KEYSTROKE DISPLAY
  ALL CLEArEd
1. Enter Offset:
    OFST 24 INCH
2. Enter bend angle:
   /
_
Ø 45.00º
3. Enter the Roll and calculate the pipe length:
    LNTH 34-7/16 INCH
Continue pressing the Travel key to view all related values.