USER’S GUIDE — 17
ENTERING DIMENSIONS
Linear Dimensions
When entering feet-inch values, enter dimensions from largest
to smallest — feet before inches, inches before fractions. Enter
fractions by entering the numerator (top number), pressing
(Fraction Bar key) and then the denominator (bottom number).
Note: If a denominator is not entered, the fractional setting
value is used.
Examples of how linear dimensions are entered (press
after each entry):
DIMENSIONS KEYSTROKE
5 feet
5 feet, 1 ½ inches
17.5 meters
m
1250 millimeters
m
Square and Cubic Dimensions
Examples of how square and cubic dimensions are entered
(press after each entry):
DIMENSIONS KEYSTROKE
14 square inches
11 square feet
3.3 square meters
m
m
3 cubic feet
To Next Page
Loading...