SECTION 4 - NORMAL PROCEDURES (continued)
D. AUTOMATIC LOCALIZER COURSE CAPTURE
By default, the GNS 430 automatic localizer course capture feature is
enabled. This feature provides a method for system navigation data present
on the external indicators to be switched automatically from GPS guidance
to localizer / glide slope guidance at the point of course intercept on a
localizer at which GPS derived course deviation equals localizer derived
course deviation. If an offset from the final approach course is being
flown, it is possible that the automatic switch from GPS course guidance
to localizer / glide slope course guidance will not occur. It is the pilot’s
responsibility to ensure correct system navigation data is present on the
external indicator before continuing a localizer based approach beyond the
final approach fix.
SECTION 5 - PERFORMANCE
No change.
SECTION 6 - WEIGHT AND BALANCE
Factory installed optional equipment is included in the licensed weight and
balance data in Section 6 of the basic Pilot’s Operating Handbook.
SECTION 7 - DESCRIPTION AND OPERATION
See GNS 430 Pilot’s Guide for a complete description of the GNS 430 system.
SECTION 4 - NORMAL PROCEDURES (continued)
D. AUTOMATIC LOCALIZER COURSE CAPTURE
By default, the GNS 430 automatic localizer course capture feature is
enabled. This feature provides a method for system navigation data present
on the external indicators to be switched automatically from GPS guidance
to localizer / glide slope guidance at the point of course intercept on a
localizer at which GPS derived course deviation equals localizer derived
course deviation. If an offset from the final approach course is being
flown, it is possible that the automatic switch from GPS course guidance
to localizer / glide slope course guidance will not occur. It is the pilot’s
responsibility to ensure correct system navigation data is present on the
external indicator before continuing a localizer based approach beyond the
final approach fix.
SECTION 5 - PERFORMANCE
No change.
SECTION 6 - WEIGHT AND BALANCE
Factory installed optional equipment is included in the licensed weight and
balance data in Section 6 of the basic Pilot’s Operating Handbook.
SECTION 7 - DESCRIPTION AND OPERATION
See GNS 430 Pilot’s Guide for a complete description of the GNS 430 system.
SECTION 9
PA-28-181, ARCHER III SUPPLEMENT 7
SECTION 9
PA-28-181, ARCHER III SUPPLEMENT 7
ISSUED: JULY 12, 1995 REPORT: VB-1611
REVISED: JULY 14, 2000 9-47
ISSUED: JULY 12, 1995 REPORT: VB-1611
REVISED: JULY 14, 2000 9-47
To Next Page