SECTION 9
PA-28-181, ARCHER III SUPPLEMENT 22
ISSUED: JULY 12, 1995 REPORT: VB-1611
REVISED: SEPTEMBER 12, 2005 3 of 10, 9-145
SECTION 4 - NORMAL PROCEDURES
To turn on the ADF-650D System:
• Depress the PWR button momentarily and release.
NOTE
If the PWR button is pressed for longer than 3 sec-
onds, the receiver will immediately shut off.
• After successful self test, input desired station frequency and select ANT
mode.
• Positively identify selected station or beacon.
• Adjust volume control as required.
• If ADF-650D System is used for navigation, select ADF or BFO mode
immediately after the station has been positively identified.
To turn off the ADF-650D System:
• Depress the PWR button for at least 3 seconds.
NOTE
If the PWR button is released within 3 seconds,
normal operations will resume.
SECTION 9
PA-28-181, ARCHER III SUPPLEMENT 22
ISSUED: JULY 12, 1995 REPORT: VB-1611
REVISED: SEPTEMBER 12, 2005 3 of 10, 9-145
SECTION 4 - NORMAL PROCEDURES
To turn on the ADF-650D System:
• Depress the PWR button momentarily and release.
NOTE
If the PWR button is pressed for longer than 3 sec-
onds, the receiver will immediately shut off.
• After successful self test, input desired station frequency and select ANT
mode.
• Positively identify selected station or beacon.
• Adjust volume control as required.
• If ADF-650D System is used for navigation, select ADF or BFO mode
immediately after the station has been positively identified.
To turn off the ADF-650D System:
• Depress the PWR button for at least 3 seconds.
NOTE
If the PWR button is released within 3 seconds,
normal operations will resume.
To Next Page
Loading...
