SECTION 9
PA-28-181, ARCHER III SUPPLEMENT 22
ISSUED: JULY 12, 1995 REPORT: VB-1611
REVISED: SEPTEMBER 12, 2005 7 of 10, 9-149
SECTION 7 - DESCRIPTION AND OPERATION (continued)
Clear (CLR)
The clear function offers several options for the operator.
• If the entire frequency is entered and the CLR button is pushed, all the
numbers will become dashes. An additional push on the CLR button will
restore and display the prior frequency entry.
• If an entry is in progress and a number is entered in error, pressing the CLR
button will erase the last number entry.
• Pressing the CLR button while in the contrast function reverses the display
image and also places the receiver in manual mode.
NOTE
It is not necessary to push CLR to enter a new frequency
number. Simply complete the entry and then enter the new
numbers and they will replace the old frequency.
Volume (VOL) Control
The audio volume control is used to adjust the settings and levels for all
function selector and setup modes and is controlled by pressing the and
buttons on the VOL control.
<
<
SECTION 9
PA-28-181, ARCHER III SUPPLEMENT 22
ISSUED: JULY 12, 1995 REPORT: VB-1611
REVISED: SEPTEMBER 12, 2005 7 of 10, 9-149
SECTION 7 - DESCRIPTION AND OPERATION (continued)
Clear (CLR)
The clear function offers several options for the operator.
• If the entire frequency is entered and the CLR button is pushed, all the
numbers will become dashes. An additional push on the CLR button will
restore and display the prior frequency entry.
• If an entry is in progress and a number is entered in error, pressing the CLR
button will erase the last number entry.
• Pressing the CLR button while in the contrast function reverses the display
image and also places the receiver in manual mode.
NOTE
It is not necessary to push CLR to enter a new frequency
number. Simply complete the entry and then enter the new
numbers and they will replace the old frequency.
Volume (VOL) Control
The audio volume control is used to adjust the settings and levels for all
function selector and setup modes and is controlled by pressing the and
buttons on the VOL control.
<
<
To Next Page