EasyManuals Logo

Piper RIP-1 User Manual

Piper RIP-1
21 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #7 background imageLoading...
Page #7 background image
Parameter Unit Value
Parameter Unit Value
Alkalinity ppm 30
Magnesium ppm 1
Aluminum ppb 15
Free Chlorine
Residual
ppm 0.5
Total Hardness ppm 7
PH s.u 8
Calcium ppm 6
Sodium ppm 7
IMPORTANT!
YOUR LOCAL WATER CONDITIONS MAY PERMANENTLY DAMAGE THIS APPLIANCE.
FAILURE TO PROPERLY TREAT WATER MAY RESULT IN DAMAGE AND
WILL VOID YOUR WARRANTY. ENSURE THAT YOUR WATER SUPPLY MEETS
THESE MINIMUM WATER QUALITY SPECIFICATIONS BELOW BEFORE INSTALLING.
FAILURE TO MEET THESE REQUIREMENTS,
AND PROVIDE PROOF OF WATER QUALITY,
WILL VOID MANUFACTURERS WARRANTY.
PLUMBING INFORMATION
A 1/4” FPT (female pipe thread) connector is provided on all units that require a water
hookup. Units with automatic humidity and/or automatic steam injection have plumbing
connections located on the right rear corner post approximately 8” up from the floor.
WARNING!: Improper voltage supplied to the unit will void the warranty.
Voltage variation can cause erratic operation and serious damage to the
electrical system.
NOTE: Piper’s automatic steam and humidity systems MUST be connected to a source
of clean and filtered water. The filter removes solid particles and dissolves minerals
(such as what is commonly found in hard water) to prevent scale build-up on the water
heating element.
5

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Piper RIP-1 and is the answer not in the manual?

Piper RIP-1 Specifications

General IconGeneral
BrandPiper
ModelRIP-1
CategoryOven
LanguageEnglish

Related product manuals