ENGLISH
8
This gas appliance is designed and certified for outdoor use only. Do not operate the grill
inside a building, garage, recreation vehicle, boat, screened porch or any enclosed area.
Keep the grill away from windy areas but keep the grill in a well-ventilated area. Do not
obstruct the flow of the combustion and ventilation air around the grill.
•
A minimum clearance of 254mm (10 inches) from the sides of the grill and a
minimum clearance of 254mm (10 inches) from the back of the grill to adjacent
vertical combustible constructions must be maintained. We strongly recommend a
305cm (10 ft.) clearance of the grill to your home or any building.
•
A minimum clearance of 254mm (10 inches) from the back of the grill above the
cooking surface to noncombustible constructions is required to allow the grill hood
to open completely. A minimum of 254mm (10 inches) clearance to the sides of the
grill above the cooking surface to noncombustible constructions is recommended.
WARNING: Do not place the grill under overhead, unprotected
combustible surfaces.
The grill is set and tested with liquid propane gas only. When purchasing a gas cylinder
for use with this unit, ensure it meets the following requirements:
1. 1 lb. capacity.
2. Marked “PROPANE.”
3. Constructed and marked in accordance with Specifications for LP Gas Cylinders
of the U.S. Department of Transportation (DOT) or the National Standard of
Canada, CAN\CSA-B339, Cylinders, Spheres and Tubes for Transportation of
Dangerous Goods; and Commission, as applicable (see label for marking).
4. Provided with a cylinder connection device that is compatible with the grill’s
regulator port.
CAUTION: It is important to inspect the cylinder connection device.
Check the propane tank valve rubber seal for cracks, wear or
deterioration prior to use. A damaged rubber seal can cause a gas
leak, possibly resulting in an explosion, fire, or severe bodily harm.
Do not use a propane tank with a damaged rubber seal.
To Next Page
Loading...
