Signing into SendPro®
Sign into SendPro® using the link in the welcome email.
spo.pitneybowes.com
Connecting the Printer Power Cord
1. Ensure you have the correct power cord for your region.
2. Connect the power cord and adapter to your printer (as shown) and
switch on.
Printer Ready
Wait for about 10 seconds until the 2 green lights remain constant and the
printer is ready.
Aligning the Label Roll
1.
Press the feed/cancel button and check that the label feeds out
correctly.
Note- If the label does not feed correctly please refer to label alignment
instructions inside the printer top cover.
2. Tear off the correctly dispensed label.
Pitney Bowes Installation Instruction November,2020 Page 4 of 17
To Next Page
Loading...
