11
4.1 Logging on to Console
Once the terminal is connected to the device, power on the Managed PoE Switch
and the terminal will display “running testing procedures”. Then, the following
message asks to log in user name and password. The factory default user name and
passwordareshownasfollowsandtheloginscreeninFigure4-3appears.
The following web screen is based on the rmware version before April 2024.
Username:admin
Password: admin
Welcome to FGSW-2624HPS it is Thu Jan 1 08:01:11 UTC 1970
Figure 4-3: Console Login Screen
The user can now enter commands to manage the Managed PoE Switch. For a
detaileddescriptionofthecommands,pleaserefertothefollowingchapters.
1. For security reason, please change and memorize the new password
after this first setup.
2. Only accept command in lowercase letter under console interface.
The following web screen is based on the rmware version of April 2024 or later.
The following message asks to log in username and password. The factory default
username and password are shown as follows and the login screen in Figure 4-4
appears.
Figure 4-4: Console Login Screen
DefaultUsername:admin
Default Password: sw + the last 6 characters of the MAC ID in lowercase
Find the MAC ID on your device label. The default password is "sw" followed by the
lastsixlowercasecharactersoftheMACID.
Model/SN:
MAC:
Managed Ethernet Device
PLANET Technology Corp.
Made in Taiwan
This device complies with Part 15 of the FCC rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
WARNING: 1) This device must be earthed. 2) For indoor use only!
SN: ZZZZZZYYMNNNNN
MAC:A8F7E0XXXXXX
MAC ID: A8F7E0XXXXXX
Default Password: swxxxxxx
("x" means the last 6 digits of the MAC address.
All characters should be in lowercase.)
Figure 4-5: MAC ID Label
To Next Page
Loading...
