Planet FGSD-1008HPS - Page 12

12
Enter the default username and password, then set a new password according to
the rule-based prompt and conrm it. Upon success, press any key to return to the
loginprompt.Loginwith"admin"andthe“newpassword”toaccesstheCLI.
Figure 4-6: Password Change Screen
The Password must contain 8 to 31 characters, including uppercase,
lowercase,numeralsand other symbols. Symbolslike|‘ \ ; ? “ & < > (
)and`cannotbeused.Pleasenotespaces(blanks)arenotaccepted.
4.2 Conguring IP Address
TheManagedPoESwitchisshippedwithdefaultIPaddressshownbelow.
IPAddress:192.168.0.100
Subnet Mask: 255.255.255.0
To check the current IP address or modify a new IP address for the Switch, please
use the procedures as follows:
 Show the current IP Address
1. Atthe“>”prompt,enter“show ip”.
2. ThescreendisplaysthecurrentIPaddressasshowninFigure4-7.
>showip
IPAddress:192.168.0.100
Subnet Mask: 255.255.255.0
Default Gateway: 192.168.0.254
DNSServer:
DHCPClient:Disabled
Figure 4-7: IP Information Screen