Planet IVC-2004PT - Wiring; Power Input Wiring

20
3.4 Wiring the Power Inputs
The 6-contact terminal block connector on the top panel of PoE
Industrial Ethernet Extender is used for two DC redundant power
inputs. Please follow the steps below to insert the power wire.
1. Insert positive / negative DC power wires into contacts 1 and 2 for
POWER 1, or 5 and 6 for POWER 2.
Input
DC 24V/48V
V1- V1+ V2- V2+
PWR1
PWR2Fault
V1- V1+ V2- V2+
Note
Must input 24V or 48V DC power source to make PoE
function workable.