Planet WRE-1200 - User Manual

Summary

Chapter 1. Product Introduction

1.2 Product Description

Provides an overview of the WRE-1200's features and benefits, including dual-band capabilities and dead zone elimination.

1.4 Product Specifications

Outlines the technical hardware and wireless specifications of the WRE-1200 device.

Chapter 3. Operation Mode Introduction

3.1 Repeater Mode

3.2 AP Mode

3.3 Client Mode

Chapter 4. Hardware Installation

4.4 Configuring the Network Properties

Guides users through configuring network properties on a PC for the WRE-1200 setup.

Chapter 5. Repeater Mode

5.1 Repeater Mode Configuration

Explains the two primary methods for configuring the repeater mode of the WRE-1200.

5.1.1 Method A - Press the WPS Push button for automatic Connection

Details the steps for automatic connection using the WPS push button in repeater mode.

5.1.2 Method B - Manual Connection by Web Browser

Provides instructions for manual configuration via a web browser in repeater mode.

Chapter 6. AP Mode

6.2 Networking Settings

Allows configuration of networking parameters like IP address and DNS servers for the AP.

6.3 Wireless Settings

Covers basic and advanced wireless settings for the 2.4GHz and 5GHz bands in AP mode.

6.3.3 Security

Explains security options for the 2.4GHz wireless network, including WEP and WPA/WPA2.

6.3.4 5 GHz 11 ac 11 an Basic Settings

6.3.6 Security

Covers security options for the 5GHz wireless network, including WEP and WPA/WPA2.

6.5.2 Updating Firmware

6.5.4 Factory Default

Chapter 7. Client Mode

7.1 Client Mode Configuration

Details the basic steps for configuring the WRE-1200 to operate in Client Mode.

Planet WRE-1200 Specifications

General

Model	WRE-1200
Wireless Standard	IEEE 802.11a/b/g/n/ac
Frequency Bands	2.4GHz, 5GHz
Maximum Data Rate	300 Mbps
Power Supply	100-240V AC, 50/60Hz
Antenna	2 x External Antennas
Security	WEP, WPA, WPA2
Operating Modes	AP, Repeater
Ports	1 x 10/100/1000BASE-T RJ45