Planet XGS3-24242 - Page 459

49-3
ipv6 pim dense-mode
To enable PIM-DM
for the specified interface
(required).
2．Configure static multicast routing entries
Command
Explanation
Global configuration mode
ipv6 mroute <X:X::X:X>
<X:X::X:X> <ifname> <.ifname>
no ipv6 mroute <X:X::X:X>
<X:X::X:X> [<ifname> <.ifname>]
To configure IPv6 static multicast routing entries.
The no form of this command will remove the
specified routing entry.
3. Configure additional PIM-DM parameters
（1）Configure parameters for PIM-DM interfaces
1) Configure the interval for PIM-DM hello messages
Command
Explanation
Interface Configuration Mode
ipv6 pim hello-interval <interval>
no ipv6 pim hello-interval
To configure the interval for PIM-DM hello
messages. The no form of this command will
restore the default value.
2) Configure the interval for PIM-DM state-refresh messages
Command
Explanation
Interface Configuration Mode
ipv6 pim state-refresh
origination-interval
no ipv6 pim state-refresh
origination-interval
To configure the interval for sending PIM-DM
state-
refresh packets. The no form of this
command will restore the default value.
3) Configure the boundary interfaces
Command
Explanation
Interface Configuration Mode
ipv6 pim bsr-border
no ipv6 pim bsr-border
To configure the interface as the boundary of
PIM-DM6 protocol. On the boundary interface,
STATE REFRESH messages will not be sent or
received. The network connected the interface is
considered as directly connected network. The
no form of this command will remove the
configuration.
4) Configure the management boundary