Planet XGS3-24242 - PIM-SM6 Typical Application

49-10
Global Configuration Mode
ipv6 pim rp-address <rp-address>
[<group-range>]
no ipv6 pim rp-address
<rp-address> {all|<group-range>}
To configure the address of the candidate RP.
The no form of this command will remove the
configuration for the candidate RP.
4) Configure the cache time of kernel multicast route
Command
Explanation
Global Configuration Mode
ipv6 multicast unresolved-cache
aging-time <value>
no ipv6 multicast unresolved-cache
aging-time
Configure the cache time of kernel multicast
route, the no
command restores the default
value.
4. Disable PIM-SM protocol
Command
Explanation
Interface Configuration Mode
no ipv6 pim sparse-mode
To disable the PIM-SM6 protocol.
Global Configuration Mode
no ipv6 pim sparse-mode
To disable PIM-DM globally.
49.2.3 PIM-SM6 Typical Application
As shown in the following figure, add the Ethernet interfaces of SwitchA, SwitchB, SwitchC and SwitchD to
corresponding VLAN, and start PIM-SM Protocol on each VLAN interface.
Figure
49-2 PIM-SM Typical Environment
SwitchA
SwitchB
Vlan 1
vlan 1
Vlan 2
rp
Vlan 2
Vlan 2
Vlan 2
bsr
Vlan 1
Vlan 1
Vlan 3
Vlan
3
SwitchD
SwitchC