Planet XGS3-24242 - Port Configuration Example

7-3
rate-violation <200-2000000>
[recovery <0-86400>|]
no rate-violation
Set the max packet reception rate of a port. If
the rate of the received pack
et violates the
packet reception rate, shut down this port and
configure the recovery time, the default is
300s.
The no command will disable the
rate-violation function of a port.
Global Mode
port-rate-statistics interval [<interval
-value>]
Configure the interval of port-rate-statistics.
3. Virtual cable test
Command
Explanation
Port Configuration Mode
virtual-cable-test
Test virtual cables of the port.
7.3 Port Configuration Example
Figure 7-1 Port Configuration Example
No VLAN has been configured in the switches, default VLAN1 is used.
Switch
Port
Property
Switch1
1/0/7
Ingress bandwidth limit: 50 M
Switch2
1/0/8
Mirror source port
1/0/9
100Mbps full, mirror source port
1/0/10
1000Mbps full, mirror destination port
Switch3
1/0/12
100Mbps full
1/0/7
Switch 2
Switch 3
1/0/9
1/0/12
1/0/8
1/0/10
Switch 1