Planet XGS3-24242 - Page 536

53-3
2． Enable the number limitation function of MAC、IP in VLAN
Command
Explanation
VLAN configuration mode
vlan mac-address dynamic maximum
<value>
no vlan mac-address dynamic
maximum
Enable and disable the number limitation
function of MAC in the VLAN.
Interface configuration mode
ip arp dynamic maximum <value>
no ip arp dynamic maximum
Enable and disable the number limitation
function of ARP in the VLAN.
ipv6 nd dynamic maximum <value>
no ipv6 nd dynamic maximum
Enable and disable the number limitation
function of NEIGHBOR in the VLAN.
3． Configure the timeout value of querying dynamic MAC.
Command
Explanation
Global configuration mode
mac-address query timeout <seconds>
Configure the timeout value of querying
dynamic MAC.
4．Configure the violation mode of ports
Command
Explanation
Port mode
switchport mac-address violation {protect
| shutdown} [recovery <5-3600>]
no switchport mac-address violation
Set the violation mode of the port, the no
command restores the violation mode to
protect.
5．Display and debug the relative information of number limitation of MAC and IP on ports
Command
Explanation
Admin mode
show mac-address dynamic count {vlan
<vlan-id> | interface ethernet
<portName> }
Display the number of dynamic MAC in
corresponding ports and VLAN.
show arp-dynamic count {vlan
<vlan-id> | interface ethernet
<portName> }
Display the number of dynamic ARP in
corresponding ports and VLAN.