FEATURES
4
5
NOTE
If you have
installed a
Plantronics
Handset
Lifter please
refer to the
sections
“Making and
Receiving
a call using
the Lifter”
on page 7.
PLACING A CALL
USING YOUR HEADSET
To place a call using the headset, the system
must be in headset mode. Take the handset
off hook and dial in the normal way. You will
then be able to talk through your headset.
When the call is complete, return the
telephone handset to the cradle.
RECEIVING A CALL
USING YOUR HEADSET
When your telephone rings take the handset
off hook. Ensure that your CS50 Wireless
Office Headset System is in headset mode.
You will then be able to talk through your
headset.
When the call is complete, return the
telephone handset to the cradle.
PLACING AND RECEIVING
A
CALL USING HANDSET
In handset mode the telephone can be used
to make and receive calls in the normal way.
Ensure that your CS50 Wireless Office
Headset System is in handset mode.
OUT OF RANGE WARNING
As you walk away from the base unit you will
eventually reach the system operating range
limit. When in headset mode a warning
alert of two beeps will sound in the headset
shortly before you meet the range limit.
On hearing this alert you should walk closer
to the base unit to ensure call quality is
maintained.
If you remain out of range for more than
15 minutes the system will drop the call
permanently. If using a Plantronics Handset
Lifter the handset will be replaced and the
call terminated.
LOW BATTERY WARNING
When the headset battery is running
low (approximately 5 minutes talk time
remaining), an audible warning will be
heard through the headset as a single
beep repeating every 10 seconds. Soon
after hearing this warning, you should
recharge the headset.
FEATURES
BASICS
To Next Page
Loading...
