Plinius P100 - Precautions; Placement & Ventilation; Installation & Operation

PLINIUS P100 5
Precautions
PLEASE TAKE SPECIAL NOTE OF THE FOLLOWING PRECAUTIONS BEFORE
OPERATING YOUR P100.
Ǟ DO NOT place objects lled with liquids, e.g. vases, on your phono preamplier, or in
any position where liquids or foreign material may enter it.
Ǟ DO NOT place sources of naked ame, e.g. candles, on your phono preamplier, or
leave ammable material on it whilst running, as this could pose a serious re risk.
Ǟ DO NOT connect any input of your phono preamplier to its own inputs or outputs, or
any voltage source or appliance, other than suitable phono turntables.
Ǟ DO NOT connect any output of your phono preamplier to earth, ground, its own
inputs or outputs, or any voltage source or appliance, other than suitable audio
preampliers.
WARNING: RISK OF ELECTRIC SHOCK.
Ǟ This preamplier operates at hazardous voltage levels. We recommend any work
requiring removal of the lid be referred to a suitably qualied and experienced service
technician.
Placement & Ventilation
The following are placement and ventilation guidelines.
Ǟ The ideal location is upon a rigid stand.
Ǟ The phono preamplier should be kept well ventilated and away from direct sources
of heat, such as sunlight.
Ǟ When stacking separate audio components, ensure a minimum of 400mm clearance
above the top unit is maintained for suitable airow.
Ǟ NOTE: This unit has been designed for use in moderate climates only, not for tropical
conditions.
Installation & Operation
PLEASE READ AND UNDERSTAND THE PRECAUTIONS WITHIN THIS MANUAL
FOR PLACEMENT & OPERATION OF THIS PRODUCT.
CONNECTIONS
Connections to your P100 should be made in the same order as they are listed below.
DO NOT attempt to connect your P100 until you have read and fully understood these
instructions. Should you require further assistance, please contact your Plinius dealer.