7.
During data
saving on the
device special autodiagnostic mode can
be executed (in case of changing
measurement data: counter value, pulse
factor), which is displayed as "SEr 5"
sign.
This mode lasts for about 60 seconds, and it
causes DP structure, DP values, current data
sending to the system. If this mode do not
appear automatically it has to be done
manually basing on SERVICE MENU
If during "SEr 5" display the diagnostic
phone number will be programmed
(from "Options" menu), then device will
additionally send the text message with
installation summary to this number.
8.
Remove the OptoBTEx
interface. (G) icon should disappear.
After finishing the installation check on
the display if the counter value was set
properly.
To Next Page
Loading...