Plum MacR6-Z0 - Page 43

SETTINGS
D-8
MacR6-Z0 – USER MANUAL
NTP Server
46
NTP server address to synchronize devices clock. Can be the IP address or
domain name i.e.: ntp.plum.com
Address must be available in the SIM card APN space
APN
35
APNs name, which in the SIM card operates. i.e.: internet
Data Server
Address
37
Data server address in form of address:port. Can be the IP address or domain
name, i.e.: www.ewebtel.com:80, 192.168.0.2:5555
Schedule Type
23
Type of report sending schedule:
1 - report sent daily
2 - report sent weekly
3 - report sent monthly
Registration
period
30
Data registration period: set from 1 to 60 minutes as total aliquots of 60.
Hs
33
Heat combustion value
Tel Num
58
Diagnostic phone number - used while installation process. Able to set only
while "SEr 5" mode is performing. After setting this parameter the recorder will
send the SMS with installation summary. Example: [country dial code w/o +][9-
digits phone number] – 48601123456
P Min Alarm
65
Second Lower pressure value to activate alarm
P Max Alarm
66
Second Higher pressure value to activate alarm
P Min Warning
67
First Lower pressure value to activate alarm
P Max Warning
68
First Higher pressure value to activate alarm
P offset st
111
Gauge pressure reset. 1-start reset, 2-offset calculation, 0-calibration offset
value reset
P offset val
112
Calibration offset value – calculated