Pocket Radar SD2000 - Getting Started; Set up Instructions

GETTING STARTED
8
Set Up Instructions
1. Insert the small end of one of the 6 ft (2 meter) Type A to
Micro B cables into the Smart Display and the other end
into the 2 amp AC power supply (USB charger). Then plug
the 2 amp AC power supply into any power outlet.
2. Insert the small end of the other 6 ft (2 meter) Type A to
Micro B cable into the Pro Radar Module and the other end
into the Smart Display (pass USB cable under the plastic
Strain Relief strap).
3. Press the Power (red) button on the Smart Display, and
you’re ready to start capturing speeds.
 •Seenextpageforillustrations.
If you plan on using standard Alkaline C-size batteries or a USB Power
Pack as your power source, please refer to page 16 in this Manual.
IMPORTANT NOTE: If the Pro Radar Module is not connected to
the Smart Display, “no rdr” will ash for 2 minutes until it powers off
automatically. To turn off the Smart Display, simply hold the Power (red)
button down for 1 second. Once “Off” is displayed, release the button
and the Smart Display is now turned off. Please note that the speed
memory stored in the Smart Display will be erased as well.
Pro Radar Module
PRO RADAR MODULE
™
GETTING STARTED