ADVANCED MENU
Holding down the Power (red) and Mode (black) buttons at the same
time for more than 2 seconds will bring the user into the advanced menu
listed below. Release both buttons when desired menu is shown.
1. Measurement Units (vnt): see page 21
• Allows the user to change units of measurement between
either MPH or KPH.
2. Sensitivity / Range (sen): see pages 22 and 27
• Allows the user to control the sensitivity and measurement
modes of the Pro Radar Module.
3. Auto - Off / Power - Off Timer (tof): see page 23
• Allows the user to specify how long the Display should re-
main on before it automatically turns off.
4. Auto - On (aon): see page 24
• Allows the user to have the system automatically turn on
when external power is supplied. Useful in permanent
installations.
5. Brightness (br): see page 25
• Allows the user to manually adjust the visibility of the Display
from Auto (default) to Low (dim) or High (very bright).
6. Version (Uer): see page 26
• Allows the user to identify which version of rmware
their Smart Display or radar contains.
20
PRO RADAR MODULE
™
ADVANCED MENU
To Next Page
