PocketWizard FlexTT5 - HyperSync

Advanced Wireless CLS / i-TTL
Flash on camera
1. Slide MiniTT1
®
Transmitter or FlexTT5
®
Transceiver onto camera.
2. Slide Nikon SB-800 or SB-900 Speedlight onto camera mounted MiniTT1 or FlexTT5
radio. Set Speedlight for MASTER = ON. Use controls on MASTER Speedlight to set
remote groups/zones. Nikon SU-800 Wireless Speedlight Commander may also be used.
Camera menus can not be used.
3. Slide Speedlight onto remote FlexTT5 Transceiver. Set Speedlight for standard i-TTL mode
(not REMOTE or MASTER). Repeat for each remote Speedlight.
Note: You need a receiving FlexTT5 for each remote Speedlight.
4. Set Zone Switch (A, B, C) on remote FlexTT5 to zone selection made on-camera
MASTER ash. All remote i-TTL Speedlights on the same group/zone will be treated as
one zone of light.
5. Adjust ash output level compensation using the controls on MASTER Speedlight.
6. Make sure all your PocketWizard
®
radios are on the same channel and take pictures normally.
IMPORTANT: You must be in normal i-TTL mode for remotes to operate properly. Never set
Nikon Speedlights positioned on remote FlexTT5 radios to REMOTE = ON. This will cause
improper operation. Always use Zone Switch (A, B, C) on remote FlexTT5 to set group / zone.
PocketWizard channel is used instead of Nikon channel.
ISO, aperture, ash exposure compensation (FEC), and other settings will work with exposure
normally via the PocketWizard ControlTL
®
system.
Note: Changes to camera ISO, lens zoom, etc, will not appear on remote ash LCD.
CLS / i-TTL