a
Remote ash with or without CLS / i-TTL ash on camera
1. Slide MiniTT1
®
Transmitter or FlexTT5
®
Transceiver onto camera.
2. If desired, slide Nikon SB800 or SB900 Speedlight onto camera-mounted MiniTT1 or
FlexTT5 radio and set it to MASTER mode.
3. Attach ControlTL or standard PocketWizard
®
radio to studio ash.
4. Make sure all your PocketWizard radios are on the same channel and take pictures normally.
Note: Manual remote ashes are not calculated as part of the i-TTL exposure. For proper
exposure, adjust your camera’s exposure settings, or adjust the power level directly on your
remote ash.
Use PocketWizard Utility to engage HyperSync
™
and explore faster than X-sync shutter
speeds. Visit PocketWizard.com/support/downloads for more information.
Learn about the AC3 ZoneController, PowerTracking, and controlling your Speedlights and
select studio ashes by reading the extended documentation found at:
wiki.PocketWizard.com
Manual Flash
PocketWizard Accessories
English
Studio Flash, etc.
• AC3 ZoneController for Nikon • Motor Drive cables for Remote Camera Triggering
• AC9 AlienBees Adapter for Nikon • Sync cables for studio ash triggering using the
• PowerST4 for Elinchrom RX P2 Remote Flash Triggering Port
• PowerMC2 for Einstein
™
E640 For more accessories, visit PocketWizard.com.
7
To Next Page
Loading...
