Triggering Modes
radios. Use this mode when triggering remote cameras at
greater distances. It can also be used with remote ash,
but there may be a reduction in maximum X-sync speed.
RP (Repeater) Mode automatically retransmits any
triggers received on the selected channel. Use this mode
to increase the maximum triggering distance for a remote
camera or ash by placing a Plus III half-way between a pair
of transmitting and receiving radios. This mode is
recommended for use when triggering remote cameras,
though it can be used with ash with a reduction in
maximum x-sync speed (this is not the same operation as
Auto-Relay Mode). Note: You may use multiple radios in
repeater mode for extremely long distances. Make sure
that each repealing radio can only receive the signal from
one other radio, otherwise an endless trigger loop may occur!
HSR (High Speed Receive) Mode shortens the contact
time of the FLASH/CAMERA port, allowing for triggering
of remote ashes at higher FPS (frames per second).
For more information about triggering modes, visit
wiki.PocketWizard.com
To Next Page
Loading...
