Point Mobile PM260 User Manual

WARNING:
Use only Pointmobile-approved peripherals, power cables, and power adapters. Unauthorized
peripherals, cables, or power adapters may cause batteries to explode or damage your device.
DO NOT attempt to charge damp/wet handy terminals or batteries. All components must be dry before connecting
to an external power source.
Batteries must be charged at a temperature ranging from 3~42℃ (±3℃). If you don’t follow the guide, it might
have a harmful effect on the battery life.
CAUTION:
After the battery has been charged, disconnect the DC Power Jack from the terminal. If you stay on
that plug in use, it is possible to break the power code.
☞NOTE:
Rechargeable battery packs are not initially charged. Therefore the first operation to perform is to charge
them.
☞NOTE:
If you remove the battery pack or it completely discharges, you have 30 minute window of time to insert a
charged battery pack before the backup battery completely discharges. If your backup battery completely discharges,
the contents of the RAM memory will be lost. If the backup battery is less than fully charged, there is a proportionally
smaller window of time available.
3.3. LED Indicators
The red LED is ON while charging the battery and the green LED is ON when the battery is fully
charged.
Alternatively, it is also possible to recharge the battery pack by using the single slot docking cradle,
the single slot Ethernet cradle or the 4-slot battery charger.
During the charging process the LED positioned at the right upper side of the display is red constant.
Once the charging process has been completed this LED is green constant.
If the battery pack is removed from the handy terminal, it can be recharged by inserting it into the
rear slot of the single slot docking cradle, the single slot Ethernet cradle or the 4slot battery charger.
3.4. Guidelines for Battery Pack Use and Disposal
The following are general guidelines for the safe use and disposal of batteries:
• Store the terminal and the spare batteries between 20 to 30 ºC (68 to 86 ºF) in order to
maintain optimal battery performance.
 High capacity batteries must be charged at a temperature ranging from 3~42℃(±3℃).
• Standard batteries must be charged at a temperature ranging from 3~42℃(±3℃).
• The battery level may not be displayed correctly for some minutes after the disconnection if
the handy terminal is disconnected from power supply before the charging cycle is completed.
• The handy terminal could get warm during charging. This is normal and does not mean a
malfunction.
• To achieve the best battery life, turn off the radios not in use.
• Rechargeable backup batteries and battery packs are not initially charged. Therefore the initial
operation to perform is to charge them. See below.
• By default, the battery pack is disconnected at the factory to avoid damage due to excessive
draining. Annual replacement of rechargeable battery pack avoids possible risks or
abnormalities and ensures maximum performance.
WARNING:
DO NOT attempt to charge damp/wet handy terminals or batteries. All components must be dry
before connecting to an external power source.
WARNING:
Never throw a used battery in the trash. It contains heavy metals and should be recycled according
13

Point Mobile PM260 Specifications

General

Brand	Point Mobile
Model	PM260
Category	Handhelds
Language	English