Laser Light Label
If the above laser light label is attached to your device, it indicates the product contains a
laser engine or laser aimer that emits the laser light. The following information is provided to
comply with the rules imposed by international authorities and refers to the correct use of
PM260 handy terminal.
Laser Safety Statement
This product has been tested in accordance with and complies with CDRH 21 CFR 1040.10 and
1040.11 and IEC 60825-1 Ed 2 (2007) except for deviations pursuant to Laser Notice No 50, dated
June 24, 2007. LASER LIGHT. DO NOT STARE INTO BEAM. CLASS 2 LASER PRODUCT. 1 mW MAX
OUTPUT: 650nm.
For installation, use and maintenance, it is not necessary to open the device.
Do not attempt to open or otherwise service any components in the optics cavity. Opening or
servicing any part of the optics cavity by unauthorized personnel may violate laser safety regulations. The optics
system is a factory only repair item.
Use of controls or adjustments or performance of procedures other than those specified herein may
result in exposure to hazardous visible laser light.
Use of optical systems with the scanner will increase eye hazard. Optical instruments include
binoculars, microscopes, eye glasses and magnifying glasses.
To Next Page
Loading...
Need help?
General
