point 5 Series - Failure Display and Inspection; Troubleshooting

29
GB
Pans do not become
hot and appears in
the display.
The induction hob cannot
detect the pan because it is not
suitable for induction cooking.
The induction hob cannot detect
the pan because it is too small for
the cooking zone or not properly
centred on it.
Use cookware suitable for induction
cooking. See section ‘Choosing the
right cookware’.
Centre the pan and make sure that
its base matches the size of the
cooking zone.
The induction hob or
a cooking zone has
turned itself o
unexpectedly, a tone
sounds and an error
code is displayed
(typically alternating
with one or two
digits in the cooking
timer display).
F1-F6 Temperature sensor failure . Please contact the supplier.
F9-FA Temperature sensor of the IGBT failure. Please contact the supplier.
Technical fault. Please note down the error
letters and numbers, switch
the power to the induction hob
o at the wall, and contact a
qualified technician.
FC
The connection between the display
board and the main board is fail.
Please contact the supplier.
E3/E4
Temperature sensor of the ceramic
glass plate Is high.
Please restart after the
induction hob cools down.
E5
Temperature sensor of the IGBT
Is high.
Please restart after the
induction hob cools down.
E1/E2 Abnormal supply voltage.
Please inspect whether power
supply is normal.
Power on after the power
supply is normal.
FAILURE DISPLAY AND INSPECTION
The induction hob is equipped with a self diagnostic function. With this
test the technician is able to check the function of several components
without disassembling or dismounting the hob from the working surface.
Troubleshooting
1) Failure code occur during customer using & Solution;
Failure code Possible causes What to do