point 5 Series - Before Locating the Fixing Brackets; Adjusting the Bracket Position

34
AFTER INSTALLING THE HOB, MAKE SURE THAT
• The power supply cable is not accessible through cupboard doors or
drawers.
• There is adequate flow of fresh air from outside the cabinetry to the
base of the hob.
• If the hob is installed above a drawer or cupboard space, a thermal
protection barrier is installed below the base of the hob.
• The isolating switch is easily accessible by the customer.
BEFORE LOCATING THE FIXING BRACKETS
The unit should be placed on a stable, smooth surface (use the packaging).
Do not apply force onto the controls protruding from the hob.
ADJUSTING THE BRACKET POSITION
Fix the hob on the work surface by screwing 4 brackets on the bottom of
hob (see picture) after installation.
A
B
HOB
TABLE
BRACKET
HOB
TABLE
BRACKET
Under any circumstances, the brackets cannot touch with the inner
surfaces of the worktop after installation (see picture).