33
GB
There are ventilation holes around outside of the hob. YOU MUST
ensure these holes are not blocked by the worktop when you put
the hob into position.
Min. 50 mm
Max. 5 mm Max. 5 mm
BEFORE INSTALLING THE HOB, MAKE SURE THAT
• The work surface is square and level, and no structural members
interfere with space requirements.
• The work surface is made of a heat-resistant and insulated material.
• If the hob is installed above an oven, the oven has a built-in cooling fan.
• The installation will comply with all clearance requirements and
applicable standards and regulations.
• A suitable isolating switch providing full disconnection from the mains
power supply is incorporated in the permanent wiring, mounted and
positioned to comply with the local wiring rules and regulations.
• The isolating switch must be of an approved type and provide a 3 mm
air gap contact separation in all poles (or in all active [phase] conductors
if the local wiring rules allow for this variation of the requirements).
• The isolating switch will be easily accessible to the customer with the
hob installed.
• You consult local building authorities and by-laws if in doubt regarding
installation.
• You use heat-resistant and easy-to-clean finishes (such as ceramic tiles)
for the wall surfaces surrounding the hob.
• Be aware that the glue that join the plastic or wooden material to
the furniture, has to resist to temperature not below 150
O
C, to
avoid the unstuck of the paneling.
• The rear wall, adjacent and surrounding surfaces must therefore
be able to withstand an temperature of 90
O
C.
To Next Page
Loading...
