19
3.6 Fixed IP-address
If your network has xed IP-addresses you have to enter them into the terminal.
Go to the menu selection EDIT and choose TCP/IP PARAMETERS.
Choose FIXED IP.
ACTIVE IP ADDRESS =Active IP address
DEFAULT GATEWAY = Default gateway
SUBNET MASK = Subnet mask
DNS1 / DNS 2 = Terminal does not use DNS addresses
3.7 Connection type
Go to the menu selection EDIT and choose CONNECTION TYPE.
AUTO = Terminal uses both GPRS and broadband
TCP/IP SSL = Terminal uses broadband
GPRS SSL = Terminal uses GPRS
3.8 GPRS APN
When using the terminal via GPRS you need to enter the operators GPRS APN to the
terminal settings. By default this is INTERNET. Change only if necessary.
Go to the menu selection EDIT and choose GPRS APN.
Type here the operators APN. You can check it from your operator.
The most common settings are:
DNA, Elisa and Sonera = INTERNET
Saunalahti = INTERNET.SAUNALAHTI
3. SETTINGS
To Next Page
Loading...