3
IMPORTANT SAFETY INSTRUCTIONS
The informaon contained in this technical guide is intended for Zodiac trained service personnel only.
Electrical installaon and repairs should only be performed by a cered electrician or Zodiac trained
professional. and must comply with all naonal electric codes (NEC, Canadian, etc.). state and local law,
ordinances, codes and regulaons.
If you have not received training, do not aempt any of the electrical repairs presented in this document.
Contact Zodiac Pool Stsyems, Inc. at 1-800-822-7933 for assistance.
Read and follow all instrucons carefully.
When servicing equipment, basic safety precauons should always be followed including those listed
below.
TO REDUCE THE RISK OF ELECTRICAL SHOCK:
• Disconnect main power to pool equipment area prior to any service or repairs.
• Keep all electrical equipment at least 10 feet (3m) from inside wall of pool or spa.
• Connect equipment only to a receptacle (cord models) or circuit (hardwired) protected by a
ground fault circuit interrupter (GFCI).
• Use only copper conductors and supply wires suitable for the specic device.
• Replace damaged power cord(s) immediately and use only idencal replacement parts.
• Do not bury power cord(s). Posion cord(s) to minimize abuse from lawn mowers, hedge
trimmers and other equipment.
• Do not install or service equipment if precipitaon is present or imminent.
TO REDUCE EQUIPMENT WATER PRESSURE HAZARD:
• Always turn pump o to release pressure prior to removing or installing in-line equipment.
• To avoid equipment damage, do not exceed water pressure (psi) specicaons for
the device.
To reduce the risk of injury, do not permit children to operate, handle or play on equipment.
Failure to heed the following warnings could result in property
damage, permanent injury or death.
WARNING
!
To Next Page
Loading...
Need help?
General
