EN
7
Cleaning the Filters
Always disconnect the Polaris
®
before
cleaning or backwashing the pool filter,
and let the filtration system run for at
least five minutes before re-connecting
the cleaner.
To clean the in-line filter screen, pull it out
of the filter assembly, rinse it and press it
firmly back into place.
Storage and Winterizing
Never store the cleaner in direct sunlight.
When storing for the winter, drain all the water from the cleaner
(freeze damage is not covered under the warranty). Use the Quick Disconnect
to remove the UWF from the pool wall. If necessary, use the UWF Removal Tool
available from any authorized Polaris
®
dealer.
CAUTION: in order to prevent damage to the cleaner while it is stored during winter months, it is important to drain all the
water from the cleaner.
To Next Page
Loading...
