3.40
Engine/Cooling/Exhaust
23. Reinstall the driven clutch assembly. Torque fastener
to specification.
24. Reinstall the drive belt.
25. Reinstall the airbox assembly. See “Air Box Servicing”
on page 2.24.
26. Reinstall the clutch cover/
oil tank assembly. See “Oil
Tank/Clutch Cover Service” on page 2.14.
27. Fill the coolant surge tank w
ith 60/40 Polaris engine
coolant. Follow the Cooling System Fill/Bleed
Procedure outlined in Chapter Two. See “Cooling
System Bleeding” on page 2.10.
28. Reinstall the hood assembly. See “Door/Hood
Removal and Installation” on page 2.25.
29. Reinstall the left and right door panels.
30. If the engine was rebuilt, follow the engine break-in
p
rocedure. See “Engine Break-In Procedure” on
page 2.6.
Driven Clutch Bolt Torque: 18 ft-lbs (25 Nm)
To Next Page
Loading...
Need help?
General
