Polaris DP-20 - User Manual

POLARIS DP-20
WEB GUIDE CONTROLLER
User Manual
1A
AUTOMATIC
× -ãããããÜÜÜÜÜ+
06-05-2007 © 2007 Fife Corporation. All rights reserved. Figure Sheet 1-862-D

Polaris DP-20 Specifications

General

Brand	Polaris
Model	DP-20
Category	Controller
Language	English

Summary

System Setup Menus Available From Automatic Mode

1 X.1, System Gain

Configures the system gain parameter when operating in automatic mode.

1 X.2, System Guide Point

Sets the target guide point for web guiding in automatic mode.

System Setup Menus Available From Servo-Center Mode

2 X.1, Servo-Center Gain

Adjusts the gain for the servo-center guiding mode.

2 X.2, Servo-Center Guide Point

Sets the desired guide point for servo-center operation.

System Setup Menus Available From Manual Mode

3 X.1.1, System Gain

3 X.1.4, Calibration

Guides the process of calibrating sensors for accurate guiding.

3 X.2.1, Deadband

3 X.2.7, Set Sensor Type

Advanced Menus

3 X.3.1, Restore Settings

Restores the controller to previously saved settings.

3 X.3.2, Backup Settings

Saves the current configuration settings of the controller.

3 X.3.3, Set Password

Custom Menus

3 X.5.1, ASC Control

3 X.5.2, Set ASC Limits

3 X.5.3, Set ASC Source

Troubleshooting

Fault Diagnostics - Fault Rectification

Provides guidance on diagnosing and fixing common guiding system faults.

Fault Codes

Lists and explains specific fault codes displayed by the controller for error identification.