60
PRE-RIDE INSPECTION
The following items must be checked before each use of the vehicle.
Check these items after starting the engine (see page 61), but before
putting the machine into motion.
Transmission
Make sure the reverse is not engaged before squeezing the throttle.
Engine Stop Switch
Check the auxiliary shut-off switch for proper operation. Push down to
stop the engine. Pull up to release and start the engine. See page 68.
Tether Switch
If your machine has a tether switch, make sure the engine shuts off
when the tether is removed from the switch. See page 68.
Lights
Check the headlight (high and low beam), taillight, and brake light for
normal operation.
Mirrors
If equipped, adjust your mirrors so they can be used to their full
advantage.
Operating Area
Make sure you have a clear area all around your snowmobile, including
an area clear of bystanders. There’s always the possibility of some
sideways vehicle m ovement, of applying a little more throttle than
intended, or of debris being thrown by the track. If the surrounding
area is clear you before you start, you can devote your full attention to
operating the snowmobile.
To Next Page
Loading...
Need help?
General
