Polaris Genesis 2000

ENGINE
Assembly - Polaris Engines
59 . Install reed valves in crankcase. Be sure surface of
crankcase is clean.
60 .Install reed stuffers.
61 .Install intake manifold and tighten bolts evenly in
three steps to specification following torque pattern
found on page 4.3.
108 \h jbs. (1X4 Nm) "
62 . Install new carburetor/throttle body flange gaskets
on manifold. Install carburetors/throttle bodies,
gaskets, and air intake mounting plate. Wire choke
plate closed, or cover opening in manifold to prevent
debris from entering. Torque carburetor/throttle
body bolts to specification.
Polaris Sales Inc.
4.39
3/00