Polaris Genesis 2000

FINAL DRIVE/JET PUWIP/BILGE SYSTEM
Driveshaft/Coupler
2000 Pro 1200
Lubrication Fitting
(Grease)
Rubber Bumpers
Must Be In Place
Check Sealin
Surface For Wea
Lubrication Fitting
(Grease)
Use only Polaris All Season Grease whenever
grease is recommended,
Hose Clamp Torque
35in. lbs. (4 Nm)
NOTE: Drive shaft runout
service limit - .005" (.13mm).
Inspection information found
on page 5.13.
NOTE: Drive shaft end play (fwd/rear) should
be .100-.200" (2.5-5mm) with new bumpers
3/00
5.4
Polaris Sales Inc.