Polaris msx 150 Service Manual

TAPERED SP ACER
BUMPER
DRIVESHAFT
COUPLER GUARD
BEARING CARRIER
COUPLER ASSEMBLY
ASSEMBLY NOTES
Bearing Carrier Fastener Torque: 14 ft.lbs. (19 Nm) Tighten in criss--cross pattern.
Driveshaft Run Out Service Limit: .005″ (.13mm)
Fit tapered end of spacer over driveshaft taper .
Bumper MUST be installed between impeller and driveshaft.
Use light film of premium grease on carrier seals and shaft to assist in driveshaft installation.
Apply small amount of Premium grease to tapered spacer inside diameter .
During assembly , perform the driveshaft shim procedure as outlined on page 6.10.
14 ft.lbs. (19 Nm)
SHIM WASHERS
PROPULSION
6.6
2004 Four Stroke PWC Service Manual
Driveshaft / Bearing Carrier Assembly

Polaris msx 150 Specifications

General

Brand	Polaris
Model	msx 150
Category	Boat
Language	English