111
Maintenance
Engine Oil Change
1. Position the vehicle on a level surface.
NOTE: Remove the skid plate for better access to the
oil drain plug and short screen.
2. Start the engine. Allow it to idle for two to three
minutes. Stop the engine.
3. Place a drain pan beneath the crankcase.
Remove the drain plug. Allow the oil to drain
completely.
4. Clean the crankcase sealing surface and the drain plug (with magnet) thoroughly.
5. Replace the sealing ring. Reinstall the drain plug. Torque to 15 ft. lbs. (20 Nm).
CAUTION
Hot oil can cause serious burns to skin. Do not
allow hot oil to contact skin.
Drain Plug
To Next Page
Loading...
