132
Maintenance
Lights
Brake Light Adjustment
Check the rear brake light for proper operation before
each use of the vehicle.
1. Turn the ignition key on.
2. Lightly apply and release the foot brake several times.
A properly operating rear brake light will immedi-
ately flash on and off with each movement of the
brake pedal.
3. If the light does not operate properly, grasp the switch
body with a pliers or similar tool and hold it lightly,
but securely. Using a wrench, rotate the adjustment
nut clockwise to increase tension on the spring.
NOTE: Rotate the adjusting nut counter-clockwise to decrease tension on the spring if the brake light
comes on when there is no pressure on the brake pedal.
4. Recheck and readjust as needed until the brake light operates properly.
Switch
Body
Adjustment
Nut
Spring
To Next Page
Loading...
