140
Maintenance
Spark Arrestor Clean-Out
NOTE: Refer to the illustration on page 141.
1. Remove the retaining screw and remove the arrestor from the end of the muffler.
2. Use a non-synthetic brush to clean the arrestor screen. A synthetic brush may melt if
components are warm.
NOTE: If necessary, blow debris from the screen with compressed air.
3. Inspect the screen for wear and damage. Replace a worn or damaged screen.
4. Reinstall the arrestor. Torque the screw to 5-7 ft. lbs. (7-9 Nm).
To Next Page
Loading...
