144
Maintenance
Vehicle Immersion
6. Press and hold the starter button for 10 second intervals for about one minute or until
water vapor is no longer ejecting from the spark plug hole.
7. Check the oil level. If the level is higher than the pre-ride inspection level, water has
entered the crankcase. Do not start the engine. Transport the vehicle to your dealer for
inspection and service. If the oil level is unchanged from the pre-ride inspection level,
replace the spark plug, start the engine and move the ATV promptly to a trailer or towing
vehicle.
CAUTION
If water isn't removed promptly from a submerged ATV, rust will form in precision components,
gears, bearings, the cylinder and other areas and result in serious engine damage. Always see your
dealer promptly after an ATV has been submerged.
To Next Page
Loading...
Need help?
General
