Polaris P724 - Page 7

Page 7
English
1. Seat the control unit rmly in the control unit base (Figure 1).
1
"CLICK"
2
Figure 1. Connect Control Unit Base
2. Unscrew the protective cap for the oating cable from the side of the
control unit by turning counter-clockwise (Figure 2).
Figure 2. Remove Protective Cap
3. Align the notch in the oating cable connector with the key in the control
unit, engage then turn clockwise to tighten (Figure 3).
Figure 3. Connect Floating Cable
Align:
Key with Notch