18
OPERATION
Before Starting the Engine
1. Ensure the generator is away from the fueling source.
2. The generator will vibrate during operation. Place the
generator in a dry location and on a flat, level surface.
3. Unplug all power cords and extension cords from the
generator.
4. Engage the wheel locks if they are installed.
Starting the Engine
1. Ensure the generator is away from the fueling source.
2. Unplug all power cords and extension cords from the
generator.
3. Position the fuel valve lever to ON.
4. Position the SMART throttle switch to OFF.
5. For a cold engine start, position the choke knob to
CLOSE. To restart a warm engine, leave the choke
knob in OPEN.
6. To start the generator using the ignition key, turn the
ignition switch to the START position. When the
engine starts, release the key. Do not operate the
starter for more then 10 second intervals. If it doesn’t
start turn the key to the OFF position for 5 seconds
before repeating until it starts.
7. To start the generator, using the recoil, lightly pull the
starter recoil grip until resistance is felt. Then, firmly
pull straight out.
To Next Page
Loading...
Need help?
General
