29
MAINTENANCE
as needed until the upper limit has been reached.
5. Re-install the dipstick (A). Use a clean shop rag to
clean any spilled oil.
6. Re-install the maintenance cover.
Oil Change
Oil may be hot. Do not allow hot oil to come into
contact with skin, as serious burns may result.
NOTE: Drain the oil while the engine is warm to
assure rapid and complete draining.
1. Start the engine and allow it to run for a few minutes.
Stop the engine.
2. Position the fuel valve lever to OFF.
3. Open the maintenance cover.
4. Remove the oil filler cap / dipstick (A).
5. Remove the drain bolt (B) and drain the oil. There is
a rubber plug (C) in the bottom of the generator pan
that can be removed to facilitate draining the oil. The
generator will have to be raised off the ground and
supported while the oil drains.
NOTE: Improper disposal of engine oil can be
harmful to the environment and is unlawful. Properly
dispose of used oil.
6. Drain the used oil into a sealed container and take it
to a recycling center. Do not discard the oil in a trash
can, dump it on the ground, or pour it down the
drain.
7. Re-install the oil drain bolt (B) and replace the rubber
plug (C).
Fill oil to the high limit mark (D) on the dipstick.
8. Start the engine and let it run for 1 or 2 minutes. Stop
the engine and look for leaks.
9. Re-check the oil level on the dipstick (A) and add oil
as needed to bring the level to the upper mark (D) on
the dipstick.
10. Re-install the dipstick (A).
11. Close maintenance cover.
12. Wash hands with soap and water after handling used
oil.
To Next Page
Loading...
Need help?
General
