ELECTRICAL
5.4
* Charging times can vary depending on type
of charger. Follow the charger instructions.
BATTERY ACTIVATION
WARNING
Battery electrolyte is poisonous. It contains
sulfuric acid. Serious burns can result from con-
tact with skin, eyes or clothing. Antidote:
External: Flush with water.
Internal: Drink large quantities of water or milk.
Follow with milk of magnesia, beaten egg, or
vegetable oil. Call physician immediately.
Eyes: Flush with water for 15 minutes and get
prompt medical attention.
Batteries produce explosive gases. Keep sparks,
flame, cigarettes, etc. away. Ventilate when
charging or using in an enclosed space. Always
shield eyes when working near batteries.
KEEP OUT OF REACH OF CHILDREN.
WARNING: The gases given off by a battery are
explosive. Anyspark oropen flame near a battery can
cause an explosion which will spray battery acid on
anyone close to it. If battery acid gets on anyone,
wash the affected area with large quantities of cool
water and seek immediate medical attention.
To ensure maximum service life and performance
from a new battery, perform the following steps.
NOTE: Do not activate the battery unless it will be put
into regular service within 30 days. Polaris Youth ATV
batteries are a maintenance--free design. Do not
attempt to add water or electrolyte.
NOTE: New batteries must be fully charged before
use or battery life will be significantly reduced
(10-30% of the battery’s full potential).
1. Remove the battery, battery acid, and
accessories from the box.
Electrolyte
Funnel
Battery
NOTE: Wear safety glasses and rubber protective
gloves when working with batteries.
2. Remove the protective strip from the top of the
battery. Insert the battery electrolyte funnel into
the battery holes.
3. Carefully press the battery electrolyte pack onto
the battery electrolyte funnel. The funnel will
puncture the seals on the electrolyte pack,
releasing electrolyte into the battery. Allow the
pack to drain for 20 minutes, periodically tapping
the sides to release any air--lock that may occur.
4. Properly dispose of the battery electrolyte pack.
Let battery set with the vent caps off for 30
minutes to allow full absorption of the electrolyte.
After 30 minutes , install the battery seal strip onto
the battery.
5. Charge the battery for 3 to 5 hours on the initial
charge using a Christie Multi Battery Charger or a
charger with an output 1/10th the amp rating of
the battery.
BATTERY TERMINALS/
TERMINAL BOL
TS
Use corrosion resistant Dielectric Grease (PN
2871329) on battery bolts.
Enfocus Software - Customer Support
To Next Page
Loading...
Need help?
General
