GENERAL INFORMATION
2.19
ENGINE TO FRAM GROUND
Inspect engine-to-frame ground cable connection. Be
sure it is clean and tight.
Ground
LIQUID COOLING SYSTEM
OVER
VIEW
The engine coolant level is cont r olled or m aint ained
by the recovery system. The recovery syst em
component s are the recovery bott le, radiator filler
neck, radiat or pres sur e cap and connect ing hose.
As coolant oper at ing tem perat ur e increas es, the
expanding (heat ed)ex ces scoolant isforc ed outofthe
radiat or past t he pressur e cap and int o the r ecov ery
bott le. A senginecoolantt em per at uredecreasest he
contr act ing(c ooled)coolantis dr awnbac kupf r om t he
tank past t he pressur e cap and into the radiat or.
Some coolant lev el drop on new m achines is normal
ast hesystemis purgingit self oftrappedair. Observe
coolant levels oft en during the break-in period.
Overheating of engine could occur if air is not fully
purged from system.
PolarisPremium60/40isalready pr emix edandready
to use. Do not dilute with water.
COOLANT STRENGTH / TYPE
Test the strength of the coolant using an antifreeze
hydrometer.
Antifreeze Hydrometer
S A 50/50 or 60/40 mixture of antifreeze
and distilled water will provide the
optimum cooling, corrosion protection,
and antifreeze protection.
S Do not use tap water, straight antifreeze,
or straight water in the system. Tap water
contains minerals and impurities which
build up in the system.
S Straight water or antifreeze may cause
the system to freeze, corrode, or
overheat.
Polaris 60/40 Anti-Freeze / Coolant
(PN 2871323)
COOLANT LEVEL
INSPECTION
The r ecov ery bot t le, located on the left side of the
machine, must be maint ained bet ween t he m inimum
andmaximumlev elsindicat edont herec over ybottle.
Surge Tank Cap
With the engine at operating temperature, the coolant
level should be between the upper and lower marks
on t he coolant reser v oir. I f not :
To Next Page
Loading...
Need help?
General
