32
FEATURES AND CONTROLS
Instrument Cluster
Rider Information Center
Odometer Mode
The odometer records and displays the distance traveled by the vehicle.
Trip Meter Mode
The trip meter records the distance traveled by the vehicle if reset before each trip. To reset,
select the trip meter mode. Press and hold the MODE button until the meter resets to zero. In
the Rider Information Center, the trip meter display contains a decimal point, but the
odometer displays without a decimal point.
Hour Meter Mode
This mode logs the total hours the engine has been in operation.
Engine Temperature Mode
This mode displays current temperature of the coolant.
Battery Voltage Mode
This mode displays current system voltage level.
Tachometer Mode
The engine RPM is displayed digitally.
Tip: Small fluctuations in the RPM from day to day may be normal because of changes in humidity,
temperature and elevation.
Programmable Service Interval
When the hours of engine operation equal the programmed service interval setting, the
wrench icon will flash for 5 seconds each time the engine is started. When this feature is
enabled, it provides a convenient reminder to perform routine maintenance. The service
interval is programmed at 50 hours at the factory. Use the following procedure to change the
service interval.
1. Press the MODE button until remaining service hours display.
2. Press and hold the MODE button.
3. When the service hours flash, press and release the MODE button to advance the hours
to the desired setting (including OFF). Press and hold the MODE button to set the new
service hour interval.
To Next Page
Loading...
Need help?
General
