31
FEATURES AND CONTROLS
Instrument Cluster
Rider Information Center
Use the MODE button to toggle through the information area
options.
Display Units (Standard/Metric)
The display can be changed to show either standard or metric
units of measurement for each of the following settings.
Tip: To exit the set-up mode, turn the key off. Wait 5 seconds, then turn the key on. The gauge display
the mode that was displayed prior to setting the units.
1. Turn the key to the OFF position.
2. Press and hold the MODE button while turning the key to the ON position.
3. When the display flashes the distance setting, tap the MODE button to advance to the
desired setting.
4. Press and hold the MODE button to save the setting and advance to the next display
option.
5. Repeat the procedure to change remaining display settings.
Clock Mode
Tip: The clock must be reset any time the battery has been disconnected or discharged.
1. Turn the key to the ON position. Use the MODE button to toggle to the odometer dis-
play.
2. Press and hold the MODE button until the hour segment flashes. Release the button.
3. With the segment flashing, tap the MODE button to advance to the desired setting.
4. Press and hold the MODE button until the next segment flashes. Release the button.
5. Repeat steps 3-4 twice to set the 10-minute and 1-minute segments. After completing the
1-minute segment, step 4 will save the new settings and exit the clock mode.
6. Turn the key to the OFF position.
Standard Display Metric Display
Distance Miles Kilometers
Fuel U.S. Gallons Liters, Imperial Gallons
Temperature Fahrenheit Celsius
Time 12-Hour Clock 24-Hour Clock
To Next Page
Loading...
Need help?
General
